6-2
HVR-M10C/M10E/M10J/M10N/M10P/M10U
Mechanism deck Note
LCD block LCD901 (LCD panel)
LCD block Backlight LED
Mechanism deck M901 (Drum assy) Note
Mechanism MD block
MR-048 board IC0101 (REC/PB AMP)
PD-222 board IC601 (RGB driver, Timing generator (LCD))
VA-120 board IC2100 (Video IN/OUT)
VC-367 board IC2021 (Base band process, etc.)
VC-367 board IC4001 (DV signal process,RF signal process)
MR-048 board (COMPLETE)
PD-222 board (COMPLETE)
VA-120 board (COMPLETE)
VC-367 board (COMPLETE)
VC-367 board IC8802 (EEPROM)
VC-367 board IC8002 (EEPROM)
Supporting
Replaced parts Board
EEPROM
Block replacement
Parts replacement replacement
replacement
zzz
zz
zz
zz
zz
zz zzzz
zzz zzzz
z zzz zz zz z
z
zz zzz
zz zzz
zzz
zz zzz z
zzzzzz
zzzzz
zzzzz
zz z z zz
zz z z zz z
Adjustment
Section
Mechanism
Initialization of 8,9,
A,B,C,D,13,18,1A,
1B,1C,1D page data
System control
Servo, RF
Video
LCD
Adjustment
Tape path adj.
Initialization of A, B, D, 1A,1B page data
Initialization of 8, C, 13, 18, 1C page data
Initialization of 9, 1D page data
Serial No. input
CAP FG duty adj.
Switching position adj.
Error rate check
Origin oscillation check
S VIDEO OUT Y level adj.
S VIDEO OUT chroma level adj.
COMPONENT OUTPUT level adj.
LCD automatic adj.
Contrast adj.(HD)
V COM adj.
Sample hold phase adj.
Transmissive mode white balance adj.
Reflective mode white balance adj.
1-1. Adjusting items when replacing main parts and boards.
• Adjusting items when replacing main parts
When replacing main parts, adjust the items indicated by z in the following table.
Note: When replacing the drum assy. or the mechanism deck, reset the data of page: 7, address: A7 to A9 to “00”. (Refer to “Record of Use check” of
“6-3. SERVICE MODE”)
Table. 6-1-1.
To Next Page