6-14
HVR-M10C/M10E/M10J/M10N/M10P/M10U
1-3-4. TG7 Support
1. Removal procedure
1) Remove the screw (special head screw M1.4 × 6.0) 1.
2) Remove the FP-826 flexible board 2 from the dowel A of
the TG7 support 3.
3) Remove the FP-826 flexible board 2 from the groove B of
the TG7 support 3.
4) Remove the TG7 support 3 in the direction of the arrow.
2. Attachment procedure
1) Install the FP-826 flexible board 2 into the groove B of TG7
support 3.
2) Insert the claw C of the TG7 support 3 into the groove D of
the capstan block, and fix it while aligning with the dowel E.
3) Align the round hole of the FP-826 flexible board 2 with the
dowel A of the TG7 support 3.
4) Install the screw (special head screw M1.4 × 6.0) 1.
Tightening torque: 0.059 ± 0.01N•m (0.6 ± 0.1kgf•cm)
Dowel
E
Dowel
A
Groove
D
2
FP-826 flexible board
Capstan block
Round hole
Round hole
Remove in the direction
of the arrow.
Groove
B
• Be careful not to damage the FP-826 flexible board.
Groove
B
3
TG7 support
1
Screw
(M1.4
×
6.0)
Claw
C
Points to be noted
To Next Page