Sony HVR-M25P - Page 169

6-55
HVR-M25J/M25U/M25N/M25E/M25P/M25C
Adjusting method:
Order Page Address Data Procedure
1
Set the HOLD switch of
adjustment remote com-
mander to “OFF” (NORMAL
position).
2
Set the 60i/50i SEL (OTH-
ERS menu) to “60i”.
3
Set the HOLD switch of
adjustment remote com-
mander to “HOLD” (SER-
VICE position).
40 0101
5C 42 C8 Press PAUSE (Write) button.
63 03FF
73 015A
Press PAUSE (Write) button.
(Note 2)
83 02
Check the data changes to
“00”.
93 03
Check the data is “00”. (Note
4)
10
Set the HOLD switch of
adjustment remote com-
mander to “OFF” (NORMAL
position).
11
Set the 60i/50i SEL (OTH-
ERS menu) to “50i”.
12
Set the HOLD switch of
adjustment remote com-
mander to “HOLD” (SER-
VICE position).
13 C 42 D8 Press PAUSE (Write) button.
14 3 03 FF
15 3 01 5A
Press PAUSE (Write) button.
(Note 3)
16 3 02
Check the data changes to
“00”.
17 3 03
Check the data is “00”. (Note
4)
18 C 4D
Read the data and this data
named D
4D
.
19 C 76 D
4D
Press PAUSE (Write) button.
20 C 42 C8 Press PAUSE (Write) button.
21 0 01 00
Note 2: The adjustment data will be automatically input to page:
C, address: 45 and 4D.
Note 3: The adjustment data will be automatically input to page:
C, address: 46 and 4D.
Note 4: If the data change to “01”, adjustment has error. Con-
tents of error is written into page: 3, address: C6. See the
following table.
2-6. LCD SYSTEM ADJUSTMENTS
Before perform the LCD system adjustments, check that the data
of page: 0, address: 10 is “00”.
If not, select page: 0, address: 10, and set the data “00”.
Note 1: Taken an extreme care not to destroy the liquid crystal
display module by static electricity when replacing it.
Note 2: Set the LCD BRIGHT (DISPLAY SET menu) to center.
Set the LCD COLOR (DISPLAY SET menu) to center.
1. LCD Automatic Adjustment (PD-287 board)
This adjustment does the following items automatically.
VCO Adjustment
Contrast Adjustment
Mode E-E
Signal No signal
Adjustment Page C
Adjustment Address 45, 46 (VCO Adjustment)
4D, 76 (Contrast Adjustment)
Note 1: Check that the data of page: 0, address: 10 is “00”.
Data of page: 3, address: C6 Contents of error
58 VCO adjustment error
60 Contrast adjustment error