6-54
HVR-M25J/M25U/M25N/M25E/M25P/M25C
5-5. Processing after Complete Adjustment
Perform the setting through the procedure mentioned below when
you finish the “COMPONENT OUT Adjustment (D1
BETACAM)”.
Order Page Address Data Procedure
18 00
Set the bit value of bit1 is
“0”, and press PAUSE
button. (Note)
20 1001
300
Set the bit value of bit7 is
“0”, and press PAUSE
button. (Note)
4CF
Set the bit value of bit1 is
“0”, and press PAUSE
button. (Note)
50 1000
60 0100
Note: For the bit values, refer to “6-3. SERVICE MODE”, “3-
4. 4. Bit value discrimination”.
3
(13)
8
(18)
To Next Page
Loading...
