- 7 -
AE-6A SELF DIAGNOSTIC SOFTWARE
The identification of errors within the AE-6A chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the
event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous
flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant
device number will be displayed through the LED (Series of flashes which must be counted) See table 1., non fatal errors are reported using this
method.
Flash Timing Example : e.g. error number 3
StBy LED
ON ON ON
OFF
OFF
egasseMrorrE
DEL
edoC
devreseR 10
)noitcetorPtnerruCrevO(PCO 20
)noitcetorPegatloVrevO(PVO 30
noitcetorPlacitreV 40
)edoMnoitcudorPnidelbasid,s03retfastratskcehc(BKAelbatsnU 50
noitcetorPlatnoziroH 60
noitcetorPrekaepS 70
rorrEsuBC2I 80
MVN,23C42TS.B-2M 90
draoB-A 01
draoB5B 11
draoB2J 21
draoBH 31
draoBSM 41
redoceDruoloCniaM.B-5B 51
dnekcaB,Q0512AXC.B-A 61
.corPdnuoS,1143PSM.B-A 71
desutoN 23-81
metIcitsongaiD
noitpircseD
ybdnatSsemitfooN
sehsalFDEL
esuacelbaborP
noitacoL
smotpmySdetceteD
nonruttonseodrewoPthgiltonseoD
.nideggulptonsidrocrewoP
.tiucricneposiesuF
noemoctonseodrewoP
VTehtotdeilppussirewopoN
ytluafsiylppusrewopCA
)PCO(tnerrucrevOB+semit2
)draoB1D(.detrohssi)3018/2018Q(TUO.H
)draoB1D(.detrohssi)6018Q(TEFytiraeniL
)draoB1D(.detrohssiCIrewoP1088CI
noemoctonseodrewoP
detrohssahenilrewopnodaoL
deppotsnoitcelfeDlacitreVsemit4
)draoB1D(nepo7028RdeilppustonsiV51+
)draoB1D(nepo6028RdeilppustonsiV51-
)draoBA(detrohssi1071CI
deppotssaheslupnoitcelfedlacitreV
detrohssahenilrewoP
To Next Page
Loading...
