Hint
Connect your BLUETOOTH device to the master unit.
When using the Speaker Add function, some operations can only be performed by the master unit, while others can be performed
by both the master unit and the satellite unit.
Functions that you can control only with the master unit:
pairing with BLUETOOTH devices
setting the Sleep Timer
Functions that you can control with both the master unit and the satellite unit:
adjusting the volume
switching between stereo mode and double mode
adjusting the brightness
canceling the Speaker Add function
turning candle light mode on and off
choosing the intensity of the candle light mode
Once setup is complete, the speakers can be separated by more than 1 m (3.2 ft).
If you turn off the power while the Speaker Add function is in use, when you turn the power back on, the speaker will attempt
playback using the Speaker Add function. To use the Speaker Add function, turn on the other speaker.
If you want to use the speaker that was last used with the Speaker Add function by itself, turn on the speaker, then press the ADD
(Speaker Add function) button for at least 2 seconds to cancel the Speaker Add function.
If any other BLUETOOTH device(s), such as a BLUETOOTH mouse or BLUETOOTH keyboard, is connected to the
BLUETOOTH device that is connecting with the speaker, there may be distorted sound or noise in the speaker output. In this
case, terminate the BLUETOOTH connection between the BLUETOOTH device and other BLUETOOTH device(s).
When using the Speaker Add function, the LDAC codec cannot be used. These codecs will automatically be converted to AAC or
SBC.
Note
If you want to reset one of the speakers while using the Speaker Add function, be sure to cancel the Speaker Add function. If you
do not cancel the Speaker Add function before resetting a speaker, malfunctions will occur, such as weak BLUETOOTH
connections and interrupted sounds.
You cannot listen to music from an external device connected to the AUDIO IN jack while using the Speaker Add function.
If you are using the Speaker Add function to watch videos, there may be a lag between the video and audio.
Operate the speaker (master) with the flashing BLUETOOTH indicator to connect to the BLUETOOTH
device.
When the BLUETOOTH indicator lights up, the BLUETOOTH device is connected to the speaker.
2
Start playing music on the BLUETOOTH device and adjust the volume.
Press the
/ (volume) buttons on one of the speakers to adjust the volume.
3
To Next Page
Loading...
