19
7EH, 09H, 05H, 47H, 03H, 42H, 01H, 10H, FFH
6.18 TRACK PAUSE
Function: To pause playback in the specified track
Data length: 4 bytes
Data: 03H, 43H, 01H, Track No.
Track No.: 1(01H) - 255(FFH)
Details of function: This is the command to pause playback at the top of the specified track
by entering the track number.
Example of transmission packet:
Pause playback at the top of the 18th track.
7EH, 09H, 05H, 47H, 03H, 43H, 01H, 12H, FFH
6.19 ELAPSED TIME
Function: To set to send out elapsed time
Data length: 2 bytes
Data: 07H, Status
Status: 10H = On
11H = Off
Details of function: This is the command to set whether elapsed time displayed in MDS
will be sent out or not.
MDS can send out the new time data whenever the time is renewed.
By send out this command with the value of Status On, elapsed time
of playback, FF, REW and recording are shown in sequence.
MDS sends out only the elapsed times. To display remain time, first
check the time of whole track by “TRACK TIME REQ” command and
then subtract the elapsed time from the time of whole track.
The elapsed time cannot be sent out just after remote mode is set to
ON.
Example of transmission packet:
Send out the elapsed time.
7EH, 07H, 05H, 47H, 07H, 10H, FFH
To Next Page
Loading...
