To use the
Bluetooth
function, the following
procedure is necessary.
Input passcode.
"0000"
.,1-
-
xxxx
.,
I-
-
~
4 If Passcode* input
is
required
on
the
display of the device to be connected,
input "0000."
This
unit and the Bluetooth device
memorize
each
other's
information, and
when
pairing is
made, the unit
is
ready for connection to the
device.
('----
__
-------'0
)
"0"
flashes and then stays lit
after
pairing is
complete.
S Set the Bluetooth device to connect to
this unit.
"1iI~"
or
"~~"
appears when the
connection
is
made.
* Passcode may be called "passkey," "PIN code," "PIN
number"
or
"Password," etc., depending on the
device.
Note
Pairing standby mode
is
not released until the
connection is made.
About Bluetooth icons
The
following icons are used by this unit.
lit: Bluetooth signal on
0
flashing: Pairing standby
mode
off: Bluetooth signal
off
I
it:
Connection successful
~~
flashing:
Connecting
off: No connection
Iit: Connection successful
~~
flashing: Connecting
off: No connection
d7\
'0-1
~f
flashing
(
o Pairing
When
connecting
Bluetooth devices for the
first time, mutual registration
is
required.
This
is
called
"pairing."
This
registration (pairing)
is required only for the first time, as this unit
and the
other
devices will recognize
each
other
automatically
from the next time. You
can
pair
up to 8 devices. (Depending on the
device, you
may
need to
input
a passcode for
each
connection.)
e Connection
To use the device after pairing is made, start
the connection.
Sometimes
pairing allows to
connect
automatically.
e Handsfree calling/Music streaming
You
can
talk
handsfree
and
listen to music
when the
connection
is made.
Support site
http://esupport.sony.com
http://www.xplodsony.com/
First, register
("pair")
a Bluetooth device
(cellular phone, etc.)
and
this unit with each
other.
You
can
pair
up to 8 devices.
Once
pairing
is
established, there
is
no need for pairing again.
1 Place the Bluetooth device within 1 m
(3
ft) of this unit.
2 Press and hold
([D
until"
0 " flashes
(about 5 seconds).
The
unit enters pairing standby mode.
3 Set the Bluetooth device to search for
this unit.
A list
of
detected
devices
appears
in the
display
of
the device to be connected.
This
unit is
displayed
as
"X
PLOD"
on the device
to be
connected.
•
14
To Next Page
Loading...
Need help?
General
Weight and Dimensions
