20
GB
MHC-RV8 4-240-082-11 (1)
Recording a CD by specifying
track order
— Program Edit
You can record tracks from all the CDs in the
order you want. When programming, make
sure the playing times for each side do not
exceed the length of one side of the tape.
1 Insert a recordable tape into deck B,
then press CD.
2 Program the VIDEO CD/CD tracks
following step 1 to 6 in “Programming
the VIDEO CD/CD tracks” on page 12.
3 Press CD SYNC HI-DUB.
Deck B standby for recording. The REC
PAUSE/START indicator flashes.
4 Press DIRECTION repeatedly to select
g to record on one side. Select j
(or RELAY) to record on both sides.
5 Press REC PAUSE/START.
Recording starts.
To record a disc with MP3 files by
specifying file order
After step 1, program the MP3 files following
the procedures in “To program the MP3 files”
on page 12, then proceed to step 3 above.
Tip
To check the required tape length for recording a CD,
press EDIT after you have loaded a CD in CD
function. The required tape length for the currently
selected CD appears, followed by the total playing
time for side A and side B respectively (Tape Select
Edit).
Note
You cannot use Tape Select Edit for discs containing
over 20 tracks or MP3 files.
Recording to a tape (continued)
Timer-recording radio
programs
To timer-record, you must preset the radio
station (see “Presetting radio stations” on
page 17) and set the clock (see “Setting the
clock” on page 8) beforehand.
1 Tune in the preset radio station (see
“Listening to the radio” on page 17).
2 Press CLOCK/TIMER SET on the
remote.
“DAILY1 SET” appears.
3 Press V or v repeatedly to select “REC
SET”, then press ENTER.
“ON” appears and the hour indication flash
in the display.
4 Set the time to start recording.
Press V or v repeatedly to set the hour, then
press ENTER.
The minute indication starts flashing.
Press V or v repeatedly to set the minute,
then press ENTER.
The hour indication flashes again.
5 Set the time to stop recording following
the above procedure.
The start time appears, followed by the stop
time, the preset radio station to be recorded
(e.g., “TUNER FM 5”), then the original
display appears.
6 Insert a recordable tape into deck B.
Make sure the tape is in forward direction.
7 Turn off the power.
When the recording starts, the volume level
is set to the minimum.
To Next Page
Loading...
Need help?
General
