9
GB
Getting Started
Insert the two supplied R6 (size AA)
batteries, matching the polarities as
shown below.
Notes
• Do not mix an old battery with a new one or
mix different types of batteries.
• If you do not use the remote control for a long
period of time, remove the batteries to avoid
damage from battery leakage and corrosion.
Setting the clock
You cannot set the clock in Power Saving
Mode.
1 Press "/1 to turn on the system.
2 Press CLOCK/TIMER SET.
If “PLAY SET” appears in the display
panel, press ./> repeatedly to
select “CLOCK”, then press ENTER.
3 Press ./> repeatedly to set
the hour, then press ENTER.
4 Press ./> repeatedly to set
the minutes, then press ENTER.
Changing the display
mode
The demonstration appears in the display
panel once you plug the AC power cord
into a wall socket.
Press DISPLAY repeatedly while
the system is turned off.
Demonstration
The display changes even when the
system is turned off.
No display (Power Saving Mode)
The display is turned off to conserve
power. The timer and clock continue to
work internally.
Clock
The clock display automatically turns to
Power Saving Mode after a few seconds.
Inserting batteries
To Next Page
Loading...
Need help?
General
