1-5
DCU-8000 IM
5. While closing the eject levers in the direction of arrow
1, push in the plug-in board.
6. Attach the plug-in board loose-proof assembly and the
front panel by reversing the installation steps of 2, 3.
1-4. Installing the Options
11
Eject levers
Plug-in board
1-4-2. Installing the Connector Board
Installation
1. Remove the screw or the two installing screws from
the slot into which the connector board is going to be
installed. Then remove the blank panel or the
connector board.
n
Store the removed blank panel in a safe place.
2. Insert the connector board horizontally level and
secure it with the two fixing screws.
Name of option Name of board Slot on the rear side
MKS-8701 CN-2195 Install the board into the
slot in the rear that
corresponds to the RC-90
board that is inserted in
the slot in the front.
MKS-8702 CN-2194 Install the board into the
slot in the rear that
corresponds to the IF-848
board that is inserted in
the slot in the front.
B3 x 5
Blank panel
Connector board
Fixing screw
Fixing screw
To Next Page
Loading...
