2-1
DCU-8000 IM
2-1. Troubleshooting
The main power cannot be turned on. (Indicator does not light green.)
Cannot read the Tally/GPI input correctly.
Section 2
Service Overview
Flow1
The main power of the DCU-8000 cannot be turned on.
(Indicator does not light green.)
Is the POWER switch of the DCU -8000 turned ON?
Is the power cord of the DCU -8000 connected correctly?
Is the power supply unit probably defective.
Set it to ON.
Connect it correctly.
YES
NO
NO
YES
YES
Flow2
Cannot read the Tally/GPI input correctly.
Is the DCU-8000 connector (Tally/GPI IN) connected
to the cable of the destination equipment?
Is the reference signal that matches the format of
your system input?
Is the Tally/GPI Input on the center control panel set
correctly?
Connect the cable.
Connect the correct reference signal
to input.
YES
NO
NO
Set it.
NO
YES
YES
The CA-47 board or the CN-2193 board of the
MKS-8700 is probably defective.
YES
To Next Page
Loading...
