Chapter
19
Switcher
Setup
Example of 4-split screen:
Subscreen name
Subscreen
Example of 10-split screen:
Example of 16-split screen:
In the following description, a split window is referred to
as a “subscreen.”
1
In the Engineering Setup >Switcher >Output menu
(7333), press [Multi Viewer].
The Multi Viewer menu (7333.9) appears.
2
In the <Multi Viewer> group, press [1] or [2] to select
the setting target.
The status area shows a list of outputs assigned to the
subscreens.
3
In the <Split Mode> group, select the number of split
windows.
Split 4: Splits the screen into 4 windows.
Split 10: Splits the screen into 10 windows.
Split 16: Splits the screen into 16 windows.
Notes
The following limitations apply when [Split 16] is
selected.
•
The subscreens are arranged in pairs (1 and 9, 2 and
10, up to 8 and 16). If one subscreen in a pair has no
input signal, then the video on the other subscreen
may not be displayed normally. For example, if
subscreen 1 has no input signal, then the image on
subscreen 9 may not be displayed normally.
•
The video on subscreens has a reduced refresh rate.
Consequently, rapidly-changing images may not be
displayed smoothly.
4
To add borders to the subscreens, press [Border
Enable] to turn it on.
Tally colors
Tallies are shown on the multi viewer screen. In this way,
you can see, for example, which input signals are used in
the on-air video.
Borders appear in the following two colors.
Red border: Video with a red tally
Green border: Video with a green tally
For details about tally settings,
1
“Setting the On-Air
Tally” (p. 340) and
1
“Making New Tally Generation
Settings” (p. 375).
Notes
If [Independ] is set in the Engineering Setup >Panel
>Operation >Button Tally menu (7326.9), then tallies are
not shown on the multi viewer.
Specifying whether to show or hide the
subscreen names
1
In the Engineering Setup >Switcher >Output >Multi
Viewer menu (7333.9), select the target subscreens.
2
Press [Name Enable] to select either of the following.
Enable: Shows the subscreen name.
Disable: Hides the subscreen name.
To make the setting for all subscreens in a single
operation, turn [All Name Enable] on or off.
3
To set the name display position, adjust the following
parameters.
To Next Page
Loading...
