Independent key transition/key snapshot control section LCD
buttons
Key delegation buttons
2 Press the key snapshot button (1 to 4) of the register
you want to recall.
Key snapshot operations in the Flexi Pad
Key snapshot buttons
KEY SS button
Notes
By default, the [KEY SS] key snapshot mode selection
button does not appear in the Flexi Pad. To carry out key
snapshot saving and recall in the Flexi Pad, it is first
necessary in the Engineering Setup >Panel >Config
>Multi Function Module >Mode Sel Assign menu
(7321.21) to assign key snapshot mode to a mode selection
If the LCD buttons do not appear as the above, you must
press the [KEY SS] button to change its display to the above.
Transition control block when connected to MVS-6520/3000A/3000
(ICP-6520/6530 PGM/PST bank)
button
(
1
p. 328).
Press the [KEY SS] button on the Flexi Pad to switch the
memory recall section to key snapshot mode.
Notes
For details about PGM/PST block operations when an
ICP-6520/6530 is connected to the MVS-6530,
1
“8-
Keyer Operation” (p. 412).
Saving a key snapshot
For example, the following procedure saves the state of the
settings of key 1 on the M/E-1 bank.
1
Press the [KEY1] key delegation button in the M/E-1,
turning it on.
2
Press one of the key snapshot buttons (1 to 4) while
holding down the [K-SS STORE] (or KEY SS) button.
The color of the key snapshot button indicates the
following.
Off: Nothing is saved in the register.
Lit: Settings are saved in the register.
For a register holding a snapshot, the register name is
shown as up to eight characters.
Notes
If you save a key snapshot to a button to which settings
are already saved, the existing contents of the register
will be overwritten.
The button you pressed lights yellow.
Recalling a key snapshot
For example, the following procedure recalls the state of
the settings of key 1 on the M/E-1 bank.
1 Press the [KEY1] key delegation button in the M/E-1,
turning it on.
Region selection buttons Memory recall section
For example, to carry out operation on key 1 of the M/E-1
bank, select [M/E-1] using the region selection buttons and
press the [KEY1] button in the memory recall section.
Use the buttons in the memory recall section to save and
recall key snapshots.
To save a key snapshot
Press and hold down the [STOR] button, and press a
register button ([1] to [4]) for the destination where you
want to save the key snapshot.
To recall a key snapshot
1 According to the information you want to recall, set
the following buttons on/off.
[MOD ENBL] button: Recall the key adjustment
values and key modifier settings.
[TRNS ENBL] button: Recall independent key
transition settings.
If both are off, then key memory is enabled, and just
the saved key fill and key source signal selections are
recalled.
To Next Page
Loading...
