Sony MXP-290 - Page 46

Connector panel
w a
~ OO ©:
° oak
OC=9 a
3) ~ AC IN receptacle
@® SUB IN (auxiliary input) 1 and 2 connectors
(phono jacks)
These connectors accept auxiliary input signals such as
those from an echo machine.
@) UBL IN (unbalanced line input) 3 through 8
connectors (phono jacks)
These connectors accept the line output signals of tape
decks
and
amplifiers
for
channels
3
through
8.
Switching
the
input
signal
between
these
connectors
and
the
MIC/LINE
IN
connectors
@
is
done
using
the
INPUT
SELECT switches @.
@ PHONO IN 1 and 2 connectors (phono jacks)
These
connectors
accept
the
signals
from
record
players
equipped
with
magnetic-moving
type
cartridges.
Switching
the
input
signals
between
these
connectors
and
the
MIC/LINE
IN
connectors
@
is
done
using
the
INPUT
SELECT
switches
@.
) SUB IN 1 and 2 connectors
4) UBL IN 3 through 8 connectors
@ MIC/LINE IN 1 through 8 connectors
H) PHONO IN 1 and 2 connectors
4) x (ground) terminal
eae ees |
@® ~ AC IN receptacle
Connect with the supplied AC power cord to an AC
power source.
@ MIC/LINE IN (microphone/line input) 1 through 8
connectors (equivalent to XLR-3-31)
These connectors accept the signals from a tape deck or
an amplifier, or the microphone signals. ‘The power can
be supplied to the phantom-powered condenser
microphone if necessary. Switching the line signals,
microphone signals, and power supply to the
microphones is done using the INPUT SELECT switches
@ and@.
@ + (ground) terminal
When this unit is connected to audio equipment such as
a record player, which requires ground connection to
reduce hum or other undesirable noise, connect its
ground wire to this terminal.
Pin assignment of XLR-3-31 and XLR-3-32 type
connectors
XLR-3-31 type XLR-3-32 type
1-5(E)
1. OPERATION ITUIHIIH