Sony PDW-U2 - Connections and Settings; Connecting to a Computer; Power Preparations

39
3-2 Connections and Settings / 3-3 Power Preparations
Chapter 3 Preparations
3-2 Connections
and Settings
3-2-1 Connecting to a
Computer
By connecting this unit to a computer, you
can use the utility software, and the other
software.
For a connection example, see 1-2 “Example of
Use” (page 32).
• The XDCAM Drive Software (see
page 38) must be installed in advance.
• To disconnect the PDW-U2 from a
Windows computer, run the “Safely
Remove Hardware” dialog, and then
disconnect the cable.
• If you start a Windows computer with the
supplied Professional Disc Drive Unit
CD-ROM loaded, the computer may fail
in normal operation or run sluggishly.
3-3 Power
Preparations
This unit can be powered by AC adaptor.
Connect the supplied AC adaptor and a
power cord (not supplied) to the DC power
inlet connector (page 36) on the rear panel
of the unit.
It is not possible to power this unit through
a USB cable.
Notes
Note