42
3-4 Handling Discs
Chapter 3 Preparations
3 Straight insert a Phillips screwdriver 4
mm or less in diameter or the like to the
hole.
4 Push the internal manual eject lever 10
mm or so, and release it.
Be careful not to insert the screwdriver
at an oblique angle or use excessive
force to push the lever.
5 Repeat Step 4 until the disc is ejected.
You may need to repeat the step about
80 times.
After ejecting the disc, it is not
necessary to return the lever to its
original position. The next time the
unit is powered on, normal operation
will resume.
6 Replace the cover.
Note
Note
Open
Turn
To Next Page
Loading...
