Operation Warnings
215
Chapter 9 Maintenance
If a problem occurs when the camcorder is
powered or is being operated, a warning is issued
by various visible and audible indicators. These
visible and audible indicators are:
• In the status display on the LCD monitor: a
warning message (“A” in the “Layout of the
table of warning messages” below) and a
warning indication (“B”)
• The WARNING indicator on the side panel of
the camcorder (“C”), and a warning sound from
the speaker and earphones (“D”)
• In the viewfinder: a warning message (“A”),
and an indicator above or below the viewfinder
screen (“E”)
The volume of the warning sound can be adjusted
with the ALARM knob. Set the ALARM knob to
the minimum position to suppress the sound.
Layout of the table of warning messages
• The operation of the WARNING indicator and
the indicators in the viewfinder is represented
by graphic symbols as follows.
: Continuous
: 1 flash/s
: 4 flashes/s
• The warning sounds are represented by graphic
symbols as follows.
: Continuous beep
: 1 beep/s
: 4 beeps/s
Operation Warnings
A
Warning
indication
State WARNING
indicator
Warning sound R EC/ TALY BATT
BCDEE
Problem VDR operation Action to take
To Next Page
Loading...
Need help?
General
