Sony PS-LX250H Replacement Guide

Replacing the stylus
To remove the stylus
1 Turn off the amplifier.
2 Grasp the stylus holder and pull it away in the direction of the arrow from the body of the
cartridge.
To install the stylus
1 Insert the stylus grip into the cartridge receptacle.
2 Push up the stylus holder until it clicks.
To remove the stylus cover
Pull the stylus cover in the direction of the arrow (forward).
To install the stylus cover
Match the grooves on the inside of the stylus cover with the rib on the stylus holder, then push
the stylus cover lightly until it is all the way on.
© 1999 by Sony Corporation Printed in China 3-867-438-11(1)
PS-LX250H
Setting the EQ switch
Set the EQ switch according to the jacks of your stereo system (amplifier).
• When your stereo system (amplifier) has PHONO input jacks (connect to PHONO input
jacks)
nset to OFF.
• When your stereo system (amplifier) does not have PHONO input jacks (connect to AUX,
VIDEO input jacks, etc.)
nset to ON.
EQ switch
ON OFF
stylus holder
stylus grip
The two parts should be flush.
rib
groove
groove

Sony PS-LX250H Specifications

Audio

signal-to-noise ratio	50 dB
wow and flutter	0.25% (WRMS)
audio recording/playback system	33 1/3 and 45 rpm

Inputs and Outputs

RCA audio output	1 (Rear)

Weight and Dimensions

weight	6 lbs. (2.7 kg)
measurements	15.7" x 3.9" x 13.5" (420 x 100 x 342 mm)