Need help?Do you have a question about the Sony PS-LX2 and is the answer not in the manual?
Power| power requirements | 120 V ac, 60 Hz |
|---|---|
| power consumption | 8W |
Motor and Drive| motor type | Linear torque BSL |
|---|---|
| drive system | Direct drive |
| control system | Magnedisc servo control system |
Performance| speed | 33V3 rpm, 45 rpm |
|---|---|
| starting characteristics | Comes to nominal speed within half revolution |
| wow and flutter | 0.02% (WRMS) |
| signal-to-noise ratio | 75dB(DIN-B) |
| load characteristics | 0.05% up to 150 g stylus force |
Tonearm and Cartridge| tonearm type | Statically balanced |
|---|---|
| stylus force adjustment range | 0-3g |
| cartridge shell weight (U.S.A. model) | 4.7 g |
| cartridge shell weight (Canadian model) | 5.2 g |
| cartridge weight range | 7.5-12 g |
| cartridge type | Moving magnet type |
| frequency response | 10 Hz to 20 KHz |
| channel separation | 20 dB at 1 kHz |
| output voltage | 3.5 mV at 1 kHz, 5 cm/sec., 45° |
| load impedance | 47 to 100 kilohms |
| tracking force | 1.5 to 2.5 g |
| stylus type | Conical 0.6 mil diamond |
| stylus weight | 5.0 g |
Weight and Dimensions| platter diameter | 31 cm |
|---|---|
| pivot-to-stylus length | 216.5 mm |
| overhang | 16.5 mm |
| dimensions | 430 x 105 x 355 mm |
| weight | 5.8 kg |
| shipping weight | 7.1 kg |
Covers safe operation, liquid/object ingress, and power cord handling.
Explains how to balance the tonearm for accurate stylus tracking and proper tracking force.
Details how to set the counterweight for the correct tracking force for cartridges.
Instructions on setting the anti-skating compensator to match tracking force for balanced playback.
Covers placing records, setting volume, speed selection, and initiating playback.
Step-by-step guide for detaching the old stylus and installing a new one safely.
To Next Page
