To Next PageTo Next Page
Need help?Do you have a question about the Sony PS-LX520 and is the answer not in the manual?
General| Platter | 300 mm aluminium alloy diecast |
|---|---|
| Cartridge type | Moving magnet |
| Output | 2.5mV |
| Recommended load impedance | 47k ohms |
| Drive method | Belt-drive |
| Motor | DC servo motor |
| Speeds | 33, 45rpm |
| Tonearm | static balance type |
| Frequency response | 20 Hz to 20, 000 Hz |
| Power requirements | 120V AC, 60 Hz |
Details for turntable, tonearm, and general system parameters like power and dimensions.
Identifies safety-critical components for proper replacement and safe operation.
Provides specifications for cartridges and lists model numbers with power requirements.
Outlines the procedure for testing AC leakage on US models to ensure safety.
Explains the purpose and operation of buttons and selectors on the front panel.
Describes rear panel connectors and the quartz lock indicator function.
Presents a high-level functional block diagram of the system's internal circuitry.
Step-by-step instructions for removing the dust cover, turntable assembly, and bottom plate.
Procedures for removing circuit boards, the tonearm drive motor, and related sections.
Detailed steps for assembling the tonearm, focusing on pipe, connector lead, and pivot mechanisms.
Continues the tonearm assembly process, detailing lifter and sensor mechanisms.
Step-by-step guide for stringing the tonearm drive cord, including preparation and execution.
Guides for adjusting stylus height, lifter height, tracking error, and record drop point.
Provides specific instructions for adjustments and visual guides for semiconductor component orientations.
Illustrates component placement on circuit boards and identifies key boards like Phono and System Control.
Shows component layouts for different models and illustrates power supply and servo board circuitry.
Detailed schematic diagrams for system control, phono, and arm switch boards.
Illustrates motor drive circuits, voltage regulators, and provides notes on schematic interpretation.
Presents detailed exploded views of the turntable's main assemblies for parts identification.
Lists general mechanical parts and initial capacitor specifications with part numbers.
Lists integrated circuits, connectors, semiconductors, and continues the capacitor list.
Detailed listing of transistors, diodes, and integrated circuits with their respective part numbers and types.
Comprehensive list of resistors, including their part numbers, carbon type, value, and wattage.
Lists switches, transformers, thermistors, accessories, and packing materials with part numbers.
Continues the list of accessories, packing materials, and manuals for different regional models.
Provides important notes and conventions for interpreting mounting diagrams, schematic symbols, and component identification.
Exploded views illustrating the breakdown of the turntable base, platter, and related sub-assemblies.
Exploded views detailing the tonearm mechanism, motor, and circuit board assemblies.
Lists mechanical parts such as screws, plates, springs, and holders with their corresponding part numbers.
Continues the list of mechanical components and provides detailed capacitor part numbers.
Comprehensive lists for capacitors, ICs, jacks, and semiconductors with part numbers and details.
Detailed listing of transistors, diodes, and integrated circuits with their respective part numbers and types.
Comprehensive list of resistors, including their part numbers, carbon type, value, and wattage.
Lists switches, transformers, accessories, packing materials, and manuals with part numbers.
