Sony PS-LX2 - Precautions; Safety Precautions

OWNER’S RECORD
PRECAUTIONS
The model and serial numbers are located at the rear. Record
these numbers in the spaces provided below. Refer to them when¬
ever you call upon your Sony dealer regarding this product.
Model No.
PS-Lt-Z,
Serial No..
WARNING
To prevent fire or shock hazard, do not ex¬
pose the unit to rain or moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified person¬
nel only.
TABLE OF CONTENTS
Features . 2
Precautions . 2
Parts identification . 3
Turntable assembly. 3
Cartridge installation . 4
Tonearm assembly . 4
Tonearm adjustment . 4
Tonearm balance adjustment
Tracking forth adjustment
Anti-skating conpensation
Connections. 6
Tips on record handling . 6
Record playing. 6
Preparation
To start playing
To lift up the stylus during play
To stop during play
Replacing the stylus . 7
Maintenance. 7
Specifications. Back cover
Trouble checks . Back cover
FEATURES
On safety
• Operate the unit only on 120 V ac, 60 Hz.
• Should any solid object or liquid fall into the cabinet, unplug the
unit and have it checked by qualified personnel before operating it
any further.
• Unplug the unit from the wall outlet if it is not to be used for an
extended period of time. To disconnect the cord, pull it out by the
plug. Never pull the cord itself.
On installation
• Place the turntable on a level surface.
• Avoid placing the unit near electrical appliances (such as a televi¬
sion, hair dryer, or fluorescent lamp) which may cause hum or
noise.
• Place the turntable where it will not be subject to any vibration,
such as from speakers, slamming of doors, etc.
• Keep the unit away from direct sunlight, extremes of
temperature, and excessive dust and moisture.
• Allow at least 10 cm (4 inches) clearance behind the unit so that
the cover can be opened.
On dust cover removal
Open the dust cover fully and slide it upward with both hands.
On repacking
Do not throw away the carton and packing materials. It is an ideal
container in which to transport the unit. When shipping the unit to
another location, secure the tonearm to the arm rest and repack it
as illustrated on the carton box.
• Magnedisc Servo System monitors the speed of the turntable
with great precision.
• The linear torque BSL (brushless and slotless) direct drive servo
motor has a high signal-to-noise ratio.
• The low-mass tonearm and cartridge allow the stylus to track
with greater accuracy.
• Servo Lock indicator illuminates lighter when the turntable starts
to rotate at nominal speed.
• Disc centering guides facilitate placing a 30 cm record over the
center spindle.
2