7
Parts and Controls
Front/Side
1
Spindle (page
11)
Mat for the platter (page 10, 12)
Platter (page
10, 11)
Place the platter on the spindle while you are
assembling your turntable. It has a drive belt
wound around on the back side.
BLUETOOTH indicator
The indicator lights blue while the turntable is
connected to the BLUETOOTH wireless
technology enabled playback device with the
BLUETOOTH function, rapidly flashes blue
while the turntable is in pairing mode, and
turns off when the BLUETOOTH function is
disabled. If there are no devices nearby that
have already been paired when you press the
BLUETOOTH button/
PAIRING button with
the BLUETOOTH function disabled, the
indicator lights orange and the turntable goes
into standby.
BLUETOOTH button/
PAIRING button
(page 14)
Enables/disables the BLUETOOTH function.
Press for about 2 seconds and release to turn
on your turntable's pairing mode.
Micro USB port
This is on the inside of your turntable when
the platter is removed.
When the updates are available (page
2),
connect your turntable to the computer via a
micro USB cable (not supplied) and update the
firmware.
Dust cover (page
10, 12)
Dust cover hinges (page
10, 12)
Storage hole for the 45 rpm adaptor
(page
10, 16)
You can store the 45 rpm adaptor when you
are not using it.
To Next Page
Loading...
Need help?
General
