91
Settings and Adjustments
Audio Output
Selects the type of audio signal output from
the HDMI OUT jack.
b Notes
• The PCM signals may not be output even when
you select “Auto” depending on the “Audio Out”
settings, number of audio channels, and the
HDMI-connected device.
• The “Audio Output” function is not available
when a DVI device is connected.
HDMI Control
Other Settings (Options)
The “Options” setup allows you to set up
other operational settings.
1 Press SYSTEM MENU while the
recorder is in stop mode.
2 Select “Initial Setup,” and press
ENTER.
3 Select “Options,” and press ENTER.
The “Options” setup appears with the
following options. The default settings
are underlined.
On Screen Display
Front Panel Display
Adjusts the lighting of the front panel display.
Auto Outputs Dolby Digital,
MPEG and DTS audio
signals as a bitstream
signal. Normally select
this position.
PCM Converts all audio signals
except for DTS signals to
PCM.
Bitstream
Priority
Select this if the
connected device is
compatible with bitstream
audio.
On Allows you to use the
HDMI control features
(page 15).
Off
Turns off the function.
On Automatically displays
information on the screen
when the recorder is turned
on, etc.
Off Displays information only
when DISPLAY is pressed.
On
Bright lighting.
Off Turns off the lighting when
the power is off.
,continued
To Next Page
Loading...
Need help?
General
