HT-CT260H
7
2-4. BACK CASE BLOCK
1 screw
(P3.5 u 12)
1 screw
(P3.5 u 12)
1 four screws
(P3.5 u 12)
1 four screws
(P3.5 u 12)
1 screw
(P3.5 u 12)
– Rear bottom view –
Note 1:
Please spread a sheet under
a unit not to injure grill side.
2 Remove the back case block
in the direction of a arrow.
5 back case block
4 connector
(XP4)
3 cushion
cushion
MAIN board
IR board
1 three screws
(P3.5 u 12)
1 screw
(P3.5 u 12)
1 screw
(P3.5 u 12)
1 screw
(P3.5 u 12)
Note 2:
When you install the connector, please install them correctly.
There is a possibility that this machine damages when not
correctly installing it.
Insert is shallow
Insert is straight
to the interior.
connector
Insert is incline
connector
connector
connector
connector connector
NGOK NG
:ire VettiQJ
To Next Page
