Sony SA-WMS335 User Manual

1
Ver 1.0 2002. 02
SERVICE MANUAL
US Model
Canadian Model
AEP Model
UK Model
E Model
SA-VE335
For the U.S. model
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
with 8 ohm loads, from 20 – 150 Hz; rated
100 watts per channel minimum RMS power,
with no more than 0.8% total harmonic
distortion from 250 milliwatts to rated
output.
SS-V335 (front and rear speakers)
Speaker system Full range, magnetically
shielded
Speaker units 5.5 × 11 cm
(7/32 × 7/16 in.), cone type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
Maximum input power: 100 watts
Sensitivity level 87 dB (1 W, 1 m)
Frequency range 90 Hz – 20,000 Hz
Dimensions (w/h/d) Approx. 70 × 152 × 126
mm (2 7/8 × 6 × 5 in.),
including front grille
Mass Approx. 830 g
(18 lb 5 oz) each
SPECIFICATIONS
SS-CN335 (center speaker)
Speaker system Full range × 2,
magnetically shielded
Speaker units 5.5 × 11 cm
(7/32 × 7/16 in.), cone type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
Maximum input power: 120 watts
Sensitivity level 89 dB (1 W, 1 m)
Frequency range 90 Hz – 20,000 Hz
Dimensions (w/h/d) Approx. 300 × 78 × 126
mm (11 7/8 × 3 1/8 × 5 in.),
including front grille
Mass Approx. 1600 g
(35 lb 4 oz)
SA-WMS335 (subwoofer)
Speaker system Active subwoofer,
magnetically shielded
Speaker unit Woofer: 20 cm (7 7/8 in.),
cone type
Enclosure type Advanced SAW type
Reproduction frequency range
26 Hz – 200 Hz
Amplifier section
Continuous RMS power output
100 W (8 ohms, 20 Hz –
20 kHz, 0.8% THD)
• SA-VE335 consists of the following models respectively.
Sony Corporation
Home Audio Company
Published by Sony Engineering Corporation
9-873-585-01
2002B0400-1
© 2002. 02
MICRO SATELLITE SYSTEM
SA-VE335/WMS335/
SS-CN335/V335
Active Subwoofer SA-WMS335
Front and Rear Speakers SS-V335
Center Speaker SS-CN335
SA-WMS335 SS-V335 SS-CN335
Inputs
LINE IN (input pin jack)
General
Power requirements
North American model: 120 V AC, 60 Hz
European model: 220 – 230 V AC, 50/60 Hz
Other models: 110 – 120 V/220 – 240 V
AC, 50/60 Hz
Power consumptions 90 W
1 W (standby mode)
Dimensions (w/h/d) Approx. 230 × 392 × 464
mm
(9 1/8 × 15 1/2 × 18 3/8 in.),
including front grille
Mass Approx. 13.2 kg
(29 lb 2 oz)
Supplied accessories
Foot pads (20)
Audio connecting cord (1)
Speaker connecting cords, 10 m (32 ft 9 3/4 in.) (2)
Speaker connecting cords, 3.5 m (11 ft 6 in.) (3)
Design and specifications are subject to change
without notice.

Sony SA-WMS335 Specifications

General

Brand	Sony
Model	SA-WMS335
Category	Home Theater System
Language	English

Summary

Service Safety and Testing

Safety Check-out Procedure

Procedure to check for AC leakage and safety compliance on exposed metal parts after servicing.

AC Leakage Test

Details acceptable AC leakage limits and methods for measurement.

Technical Diagrams

Circuit Board Locations

Diagram showing the placement of circuit boards within the SA-WMS335 unit.

Printed Wiring Boards

Layout diagrams of printed wiring boards from the component side.

Schematic Diagram

Detailed schematic for SA-WMS335 main, control, and auto power boards.

Exploded Views and Parts

Front Panel Assembly

Exploded view and parts list for the SA-WMS335 front panel section.

Rear Panel Assembly

Exploded view and parts list for the SA-WMS335 rear panel section.

Speaker Assemblies

Exploded views and parts for SS-V335 front/rear and SS-CN335 center speakers.

Electrical Component Breakdown

Auto Power, Control, and LED Components

Lists capacitors, connectors, diodes, transistors for Auto Power, Control, and LED boards.

Main and Power Board Components

Detailed lists of ICs, transistors, and resistors for Main and Power boards.

Revision History

Manual Revision Log

Details the version history and revision dates of the service manual.