Sony SL-5000 - 1-3. Adjusting the TV; Adjusting TV for Recorder Signal

ADJUSTING THE TV
Adjust your TV receiver to receive the signal from your recorder.
When you have connected a color monitor, adjusting the TV is not
necessary. ,
Channel select buttons PROGRAM SELECT
Mi A STOP/EJECT
[if
you
do
not
have
a
recorded
video
cassette
tape
if
you
have
a
recorded
video
cassette
tape
—
@ Set the RF UNIT channel selector located at the rear of the
recorder to 3CH or 4CH whichever channel is not active in your
area.
@ Push in the POWER button. The lamp lights.
@Press
the
PROGRAM
SE-
LECT
button
to
turn
the
VTR
lamp
on.
@
Select
an
active
channel
in
your
area
with
a
channel
select.
button
on
the
recorder.
© Insert the cassette with the
round window to the left.
@ Press the P button.
© Turn on the TV.
@ Set the TV receiver to either VHF channel 3 or 4 to agree with the
setting of the RF UNIT channel selector.
The TV program selected on the recorder or the tape program will
be displayed on the TV screen. If a picture does not appear on the
T\vescreen or if the display is not clear, fine tune the channel on the
TV.
@For details about TV channe! adjustment, see the instruction
manual of the TV receiver.
Check! Check!
Check
that
the
program
dis-
Check
that
the
display
on the
played
on
the
screen
changes
screen
changes
when
you
stop
when
a
different
channel
the
tape
by
pressing
the
B/
&
select
button
on
the
recorder
button
on
the
recorder.
(To
is
selected.
eject
the
cassette,
press the
if
the
program
does
not
@/
4
button
again.)
change, repeat the preceding if the program does not
steps. change, repeat the preceding
| Now your TV
| the video r
: have chos: nab
125