Sony ST-88 - Disassembly and Replacement: Exterior; Wooden Case and Front Panel Removal; Front Subchassis Removal

SECTION 2
DISASSEMBLY AND REPLACEMENT
Note: All screws in this service manual are
Phillips type (cross recess), unless other-
wise specified.
(—): slotted head
2-1. WOODEN CASE REMOVAL
1. Remove the four screws (P 4 x 16) securing the
wooden case to the chassis along with the rubber
feet.
2. Remove the two screws as shown in Fig. 2-1.
mee ANT ; |
au GRouaD [Ts00s B . Fj
ey ok . ) : :
Be x8 |
~
sy
Fig. 2-1. Wooden case removal ; ae D hee ie a
j y ~
| ats
2-2. FRONT PANEL REMOVAL
1. Remove the wooden case as described in Procedure
2-1.
2. Pull out the tuning knob.
3. Remove the four screws securing the front panel
to the chassis as shown in Fig. 2-2.
4. Remove the front panel in the arrow direction
shown in Fig. 2-3.
5. Unsolder the two lead wires from the TUNER
INPUT meter and pull out the lamp socket from
the TUNER INPUT meter bracket as shown in
Fig. 2-3.
2-3. FRONT SUBCHASSIS REMOVAL
1. Remove the wooden case and the front panel as
described in Procedures 2-1 and 2-2.
2. Remove the nine screws ( (A) ) as shown in Fig. 2-4
and Fig. 2-5.
3. Pull off the STEREO lamp from the grommet. ; Fig. 2-4. Front subchassis removal
oo