Sony STR-D611 - Page 10

Before operating the equipments with the remote
commander, be sure to set the receiver to the desired mode
by pressing one of the FUNCTION buttons.
The FUNCTION buttons are factory set in the following list.
FUNCTION to be Operating equipment
pressed
DAT DAT deck
CD CD player
TUNER Tuner
PHONO (The receiver enters the PHONO mode.)
VIDEO 1 Betamax VCRs (VCR 1)
VIDEO 2 LD player
TAPE Tape deck A
• When VIDEO 1 or 2 is pressed, the power of the selected
video equipment and TV is turned on.
Operating the equipment
1 Press the desired FUNCTION.
2 Press < (only for tape deck) or _ to start playback.
[o] ih| ,[.]jj_ I t,[:l-'f_i| Ii[_ t.-!.] i a;_11:l IJ_[_ d[o]_ I :flrii(.] tl-t
With the SELECT button, you can replace the functions
stored in the FUNCTION buttons.
To change the settings of the FUNCTION buttons
1 Press one of the FUNCTION buttons to be stored.
2 Press SELECT.
3 Press 1 to 9 button to select the desired function within 30
seconds.
With the numeric buttons from 1 to 9, the each function
can be selected as described below:
to be pressed
1
2
3
4
5
6
7
8
9
CD player
DAT deck
DECK A
DECK B
TV
LD player
VTR 1
VTR 2
VTR 3
To reset to the initial state, press the > 10 button.
Note
The 0 and ENTER buttons do not function.
List of operative buttons in SYSTEM mode (When setting
the SYSTEM/TV selector to SYSTEM)
Operating _NER" CD I DAT DE_
equipment i I A B i ...... t,2
1 • • • -- • • •
• • • _ . • •
3
- ",_, • . • -- . • •
• . , _ . , .
oO:_ - ..... .
iiiiSHl" .......
_NIDEO .... •
e*
ANT TV/ -- ......
VTR
= cHI-
PRESET .... • -- •
+1-
D SKIP -- • .....
-- • • • -- • •
i!,,_
J ,,
II -- • • • --
Do,, -- • • • -- • •
::VISUAL_---"--.... • • •
POWER
o The button is operative.
--: The button is not operative.
•*: The button can operate TV.
Note
To operate the unit correctly, the function mode of the
receiver should be same with that of the remote
commander. So, be sure to press the desired FUNCTION
button at first and then the operative button.
10