_ti _ _ iI __
i!% iii
" _' _-_ i_ii i_I_I
I_Icc] _ {Z3 C;3
____.}[C3 CC3 r-q r-q
_ _r'7 r--1£C3
]lq
w
[]
CH/PRESEI +/- buttons: Select a pfeseL s[atJorl oJ
TVNCR channel.
•_/IHt,.: Fast winding/manual search
• and _ : Forward recording
• and .< : Reverse recording
</1_: Play
m: Stop
I1: Pause
P_</_,,_,_: Locate a desired selection.
D (disc) SKIP: Disc skip (for a CD player equipped
with a multi-disc changer)
SELECT: Changes the settings of the FUNCTION button.
SYSTEM/TV mode switch
In TV mode (When setting the SYSTEM/TV selector to
TV.)
Only MUTING, MASTER VOL +/- and the operative
buttons in TV section on the list described on the next
page can be used.
[] Receiver control section
FUNCTION
PHONO, TUNER, CD, TAPE, DAT, VIDEO 1, VIDEO 2:
When each function is selected, the unit enters its
operating mode automatically.
SYSTEM OFF: Turns off the power of the whole system.
SURROUND
MODE: Selects the surround mode.
ON/OFF: Turns on/off the surround system.
REAR LEVEL +/- buttons: Control the volume of rear
speakers (surround level).
CENTER LEVEL +/- buttons: Control the volume of
center speaker (surround level).
DELAY button: Adjusts the delay time. (STR-D611 only)
T. (test) TONE: Generates a test tone signal that is sent
in succession to each speaker.
DBFB button: Turns on/off the DBFB (Dynamic Bass
Feedback).
MUTING button: Mutes the sound.
MASTER VOL +/- buttons: Control the volume level.
[] Other equipment control section
The operative buttons are changed according to the
function mode and the setting of the SYSTEM/I-V
selector.
Numeric buttons (1 to 0): Designate the number.
>10: Designates the number more than 10.
ENTER: Press after designating the TV/VCR channel.
SHIFT: Select the memory page (A, B or C) only in the
tuner mode.
TV/VIDEO selector: Selects the program to see ; IV or
VCR.
ANT TV/VTR button: Selects the output signal from the
antenna terminals on the VCR, either a TV signal or
VCR programs.
VISUAL POWER: Turns on/off the power of TV, VCR and
LD player.
Before operating remote commander, install the batteries as
shown below.
1 Open the cover.
2
Inserttwo size-AA (R6) batteries with
correct polarity.
To avoid damage caused by battery leakage and
corrosion
When the commander will not be used for a long time,
remove the batteries.
Battery life
Normal operation can be expected about a half year using
Sony SUM-3 (NS), and a year using Sony AM-3 (NW)
alkaline batteries.
When the batteries are run down, the remote commander
will not operate the unit. In this case, replace both batteries
with new ones.
9
To Next Page
Loading...
