Amplifier Operation
masterpage:Right
lename[E:\SEM_Janet\Data_DB895D\J9050665_2598514111DB895DCEL\2598514111\GB04
SC_STR-DB895D-CEL.fm]
31
GB
model name1[STR-DB895D]
[2-598-514-11(1)]
Changing the information in
the display
You can check the sound field etc. by changing
the information in the display.
Press DISPLAY repeatedly.
Each time you press DISPLAY, the display will
change cyclically as follows:
Index name of the input
a)
t Selected input t
Sound field currently applied t Volume level
When tuning in an FM/AM band
Program Service name
b)
or index name of the
preset station
a)
t Frequency t Program Type
indication
b)
t Radio Text indication
b)
t
Current Time indication (in 24-hour system)
b)
t Sound field currently applied t
Volume level
When tuning in a DAB station
Service Component Label t Frequency t
Program Type indication t Dynamic label
segment t Current Time indication (in 24-hour
system)
c)
t Channel label t Audio Info
d)
t
Signal Quality
e)
t Sound field currently
applied t Volume level
a)
Index name appears only when you have assigned
one to the input or preset station (page 47). Index
name does not appear when only blank spaces have
been entered, or it is the same as the input name.
b)
During RDS reception only (page 29).
c)
Time information appearing in the display is sent by
the DAB station. As a result, the time may not be
displayed properly if the station is located in a
different time zone.
“– –H – –M” is displayed until the time information
is received.
d)
Audio information on bit rate (32kbps - 256kbps),
signal type (stereo, dual, mono) and sampling type
(F: 48kHz, H: 24kHz) is displayed.
Example: 128K S F
e)
The DAB station sound quality is displayed.
“Q. _ _ _” is displayed until the sound quality
information is received.
Note
When “STEREO” appears in the display, the current
programme is broadcasted in the stereo/joint
(intensity) stereo mode.
Changing the display
GB01COV_STR-DB895D-CEL.book Page 31 Wednesday, June 15, 2005 9:28 AM
To Next Page
Loading...
Need help?
General