Sony TA-N330ES Service Manual

SERVICE MANUAL
TA-N330ES
SPECIFICATIONS
Other specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 4 ohm loads, both channels driven, from
20 - 20,000 Hz; rated 150 watts per channel
minimum RMS power, with no more than 0.01
% total harmonic distortion from 250
milliwatts to rated output.
With 8 ohm loads, both channels driven, from
20 - 20,000 Hz; rated 110 watts per channel
minimum RMS power, with no more than 0.05
% total harmonic distortion from 250 miliwatts
to rated output.
Continuous
RMS power
output(both
channels
driven
simultaneously)
E Model
TA-N330ES
US Model!
Canadian Model
AEP Model
UK Model
TA-N55ES
Model for
North Europe
Model except
for North
Europe
Condition
4 ohms
20 Hz - 20 kHz,
THD 0.01 %
150 W + 150 W
6 ohms
20 Hz - 20 kHz,
THD 0.03 %
125 W +125 W {100 W + 100 W
8 ohms
20 Hz - 20 kHz,
THD 0.05 %
8 ohms
monaural,
THD 0.05 %
12 ohms
monaural,
THD 0.05 %
= continued on next page —
STEREO POWER AMPLIFIER
SONY.

Sony TA-N330ES Specifications

General

Damping Factor	100
Type	Power Amplifier
Power Output	100W per channel (8 ohms)
Frequency Response	1Hz to 100kHz
Input Sensitivity	1V
Output	Speaker Outputs
Dimensions	430 x 150 x 380 mm

Summary

Specifications

Audio Power Specifications

Details power output and total harmonic distortion for various loads and conditions.

Other Technical Specifications

Lists other technical parameters such as dynamic power, frequency response, and damping factor.

General Information

System Overview and Power

Describes the amplifier system, power requirements, and consumption for different market models.

Physical Characteristics

Covers physical dimensions, weight, and supplied accessories for the unit.

Servicing and Safety

Safety Check-out Procedures

Outlines essential safety checks, including AC leakage testing, after servicing.

AC Leakage Testing Methods

Explains methods to test AC leakage from exposed metal parts to earth ground.

Section 1 General

Front Panel Controls Overview

Identifies and describes the function of each front panel control and indicator.

Section 2 Electrical Adjustments

Adjustment Precautions

Provides essential precautions before performing electrical adjustments.

Idling Adjustment Procedure

Details the step-by-step process for adjusting the amplifier's idling current.

Section 3 Diagrams

Circuit Board Locations

Shows the physical location of various circuit boards within the unit.

Printed Wiring Board Layouts

Presents the layout diagrams for the printed wiring boards.

Section 4 Exploded View and Parts List

Cabinet Section Assembly

Provides an exploded view and parts list for the cabinet assembly.

Section 5 Electrical Parts List

Accessories and Packing Materials