EasyManua.ls Logo

Sony TC-RE340 - Tc-Ke240

Sony TC-RE340
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
Tape Speed Adjustment
Procedure:
Mode: playback
1. Set to the test mode (See page 12).
2. Press the H button to playback.
3. Adjust RV301 so that the frequency counter reading becomes
3,000±90 Hz.
4. Frequency difference between the beginning and the end of
the tape should be within 3%.
Adjustment Location: MAIN board (See page 14)
Sample value of Wow and Flutter: 0.3% or less W.RMS (JIS)
(WS-48B)
Playback Level Adjustment
Procedure:
Mode: playback
Adjust RV121 (L-CH) and RV221 (R-CH) so that the reading on
level meter meets the adjustment limits below.
Adjustment Limits:
LINE OUT level: –7.7±0.5 dB (0.301 to 0.338 V)
Level difference between channels: within 0.5 dB
Check that the LINE OUT level does not change even if playback
and stop operation is repeated several times.
Adjustment Location: MAIN board (See page 14)
+
set
LINE OUT jack (J301)
frequency counte
r
test tape
WS-48B
(3 kHz, 0 dB)
47 k
+
set
LINE OUT jack (J301)
47 k
test tape
P-4-L300
(315 Hz, 0 dB)
level meter
Bias Consumption Current Adjustment (TC-RE340 only)
Procedure:
1. Set RV141 (L-CH) and RV241 (R-CH) to mechanical center
and turn the set recording mode.
2. Connect digital voltmeter as shown by the following table.
3. Press the H button to playback.
4. Adjust the following transformers for the minimum readings
on the digital voltmeter.
Measurement Point Adjustment Part Value
L-CH TP301 pin 2 and 3 T101
minimum
R-CH TP301 pin 1 and 2 T201
Specified value: Maximum 220 mV
Adjustment Location: MAIN board (See page 14)
Record Bias Adjustment
Setting:
[REC LEVEL] volume: standard record position (See page 12)
Procedure:
Mode: record and playback
1. Set to the test mode (See page 12).
2. Press the [REC ] button then the H button to start record-
ing.
3. Press the x button to stop recording and press the H button
to playback.
4. Adjust TC-KE240: RV142 (L-CH) and RV242 (R-CH), TC-
RE340: RV141 (L-CH) and RV241 (R-CH) so that 10 kHz
playback output is 0±0.3 dB relative to the 315 Hz output.
Adjustment Location: MAIN board (See page 14)
+
set
LINE IN jack (J301)
(no signal)
TP301
3
2
1
L-CH
R-CH
47 k
digital voltmeter
CS-413 blank tape
set
47 k
AF OSC
Attenuator
LINE IN jack (J301)
315 Hz
10 kHz
50 mV (–23.8 dB)
600
10 k
CS-123
blank tape
LINE OUT jack (J301)
level meter
+
TC-KE240
TC-RE340
adjustment screw
adjustment screw
z
Adjustment Location: record/playback head
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com

Related product manuals