Sony TRINITRON KV-25 XSD - Functions of Controls; On the Set Controls; Inside the Panel Controls

On-screen display
Bar display
On-screen display
Indicates programme numbers and @- input mode.
Bar display
Indicates the level of = volume, @ colour, <+ brightness,
0 contrast, 9: bass, § treble and x balance.
e Note on x function.
When the volume is at the minimum setting the balance
ts. function will not operate.
© power switch
Use © to switch the set on and off. Press this switch, if you
want to cut off the mains power completely.
e To ensure correct operation push the switch in fully.
© standby indicator
Lights up brightly when the set is in the standby mode.
e Ifthe main power is turned off whenin standby mode. The
standby indicator will take 2 to 6 seconds to go off.
€ space sound indicator
Lights up when & on the Remote Commander is pressed.
A/B indicator
One of them lights during bilingual broadcast. (Choose Aor
B with the Remote Commander.)
Both light during stereo broadcast. In AV mode, A lights for
left channel, B for right channel, or A and B for both chan-
nels.
Remote control detector
Point the Remote Commander towards this detector.
( headphones jack (stereo minijack)
Connect only a stereo headphone.
A/B indicator
ORGo)
Remote control
detector
-
PROGR
“Inside the panel
= search buttons
Press to fine tune a weak channel manually, if required.
When &1(SEARCH) is pressed, the indicator goes off and
the (AFT) circuit does not function on the selected
channel.
To restore the (AFT) circuit on this channel, press
(AFT) so that the indicator lights up.
(4) AFT button and indicator
Normally, press Ge (AFT) so that the indicator Ights up.
The AFT circuit automatically fine tunes the channels for
the best possible picture.
— volume buttons
PROGR programme scan buttons
TV button
e The TV button will not function on this set.