2
Communication Format.......................................... 2
Command Block Format ........................................ 3
Communication Protocol ........................................ 3
Connections .............................................................. 4
Features of the Command Protocol ....................... 4
Command Table ...................................................... 5
Command Description ............................................ 6
Input Config (21H) ................................................ 6
Selected Offset (28H) ............................................ 6
On Switch Function (29H) .................................... 7
Off Switch Function (2AH)................................... 7
Select Display (2BH)............................................. 7
Select Menu (2CH)................................................ 7
Select Caption (2EH)............................................. 8
Select RGB Mode (2FH) ....................................... 8
White Balance Data (40H) .................................... 8
Preset Data (41H) .................................................. 9
NV RAM Save (45H).......................................... 10
Preset Adjust (47H) ............................................. 10
Sub Control Data (4CH) ...................................... 11
V Hold Data (4DH) ............................................. 11
Reset Data (4EH)................................................. 11
Split Phase Data (51H) ........................................ 12
Status Sense 1 (60H) ........................................... 12
White Balance Sense (61H) ................................ 12
Preset Sense (62H) .............................................. 12
Sub Control Sense (6BH) .................................... 12
V Hold Sense (6CH)............................................ 13
Status Sense 2 (6DH) .......................................... 13
Status Remote (6EH)........................................... 13
Status Reply 1 (70H) ........................................... 13
White Balance Reply (71H) ................................ 14
Preset Reply (72H) .............................................. 14
Sub Control Reply (7BH).................................... 14
V Hold Reply (7CH) ........................................... 14
Status Reply 2 (7DH) .......................................... 14
Status Remote Reply (7EH) ................................ 15
ACK Reply (04H) ............................................... 15
NAK Reply (05H) ............................................... 15
Contents
Start Bit Stop Bit
“1” (Mark)
Communication Format
Asynchronous, bit serial signal
• Based on RS-232C
• Data signaling rate: 9600 baud/sec
The bit composition is defined as follows:
1 START bit +8 DATA bits + 1 PARITY bit + 1 STOP bit
PARITY: Even
STOP BIT: One bit
Bit 0
(LSB)
Bit 1 Bit 2 Bit 3 Bit 4 Bit 5 Bit 6 Bit 7
(MSB)
Parity
Bit
“0” (Space)