USB DAC AMPLIFIER
UDA-1
Preparing the remote control
Before using the remote control for the first time, remove the insulation film.
The battery is installed in the remote control at the factory.
Replacing the lithium battery
The working distance of the remote control shortens as the battery becomes exhausted.
Replace the battery with a new one following the procedure below.
1. Take out the battery case as shown below.
2. Replace the lithium battery CR2025 with a new one, with the + side facing up.
3. Place the battery case back in position.
Note
Keep the lithium battery out of the reach of children.
Should the battery be swallowed, immediately consult a doctor.
Help Guide
How to Use
To Next Page
Loading...
