How to fix image extending beyond the screen on Sony VPL-DX10 Projector?
If the image extends beyond the screen on your Sony Projector: * The APA key has been pressed even though there are black edges around the image: Display the full image on the screen and press the APA key. * The screen setting is not proper: Adjust “Shift” on the Screen setting menu.
How to fix a Sony VPL-DX10 that won't turn on?
If your Sony Projector is not turning on, make sure the AC power cable is firmly connected. Also, check that the lamp or lamp cover is securely closed.
Why is the picture too dark on my Sony VPL-DX10?
If the picture on your Sony Projector is too dark, it could be due to improperly adjusted contrast or brightness settings. Adjust the Contrast or Brightness in the Picture menu. It's also possible that the lamp has burnt out or is dim. Check the Lamp Timer in the Information menu.
How to fix incorrect color balance on Sony VPL-DX10 Projector?
If the color balance on your Sony Projector is incorrect, the image quality setting may not be proper; adjust it in the Picture menu. Also, the setting of “Input-A Signal Sel.” in the Setup menu might be incorrect; select “Computer,” “Video GBR” or “Component” according to the input signal. Finally, ensure “Color System” in the Setup menu matches the color system being input.
Why is the picture not clear on my Sony VPL-DX10?
If the picture on your Sony Projector is not clear, it may be out of focus. Adjust the focus to correct this. Another potential cause is condensation on the lens. If this is the case, leave the projector on for about two hours to allow the condensation to dissipate.
Why is the aspect ratio of the display not right on my Sony VPL-DX10 Projector?
If the aspect ratio of the display is not right on your Sony Projector, adjust “Aspect” on the Screen setting menu.
Why is the LAMP/COVER indicator flashing orange with 3 flashes on my Sony VPL-DX10 Projector?
If the LAMP/COVER indicator is flashing orange with a repetition rate of 3 flashes, it could be due to the interior of the unit reaching a high temperature. Make sure nothing is blocking the fresh-air inlet and exhaust outlet. It could also mean the lamp has reached a high temperature, in which case you should wait for 90 seconds for the lamp to cool, then turn the power on again.
How to turn on on-screen display on Sony VPL-DX10?
If the on-screen display does not appear on your Sony Projector, check if “Status” in the Setup menu has been set to “Off.” If so, set it to “On.”
What does it mean when the ?/1 key flashes red on my Sony VPL-DX10?
If the ?/1 key flashes red with a repetition rate of 2 flashes, it indicates that the internal temperature is unusually high. Check to see that nothing is blocking the ventilation holes. It could also mean the projector is being used at a high altitude; in this case, ensure that “High Altitude Mode” in the Setup menu is set to “On.”
Why is the LAMP/COVER indicator flashing orange on my Sony VPL-DX10 Projector?
If the LAMP/COVER indicator on your Sony Projector is flashing orange with a repetition rate of 2 flashes, it means the lamp cover is detached. Attach the cover securely.
General| Resolution | 1024 x 768 (XGA) |
|---|---|
| Contrast Ratio | 2000:1 |
| Display Technology | 3 LCD |
| Projection Size | 30 to 300 inches |
| Aspect Ratio | 4:3 |
| Lamp Type | UHP |
| Input Connectors | S-Video, Composite Video |
| Power Consumption | 220W |
To Next Page
