To Next Page
N
Nicole ElliottSep 5, 2025
How to make input terminals appear on Sony Projector?
- SStephen JonesSep 6, 2025
Set “Auto Input Search” in the Function menu to “Off” to make input terminals appear on your Sony Projector.
How to make input terminals appear on Sony Projector?
Set “Auto Input Search” in the Function menu to “Off” to make input terminals appear on your Sony Projector.
How to fix Sony VPL-HW55ES power not turning on?
If your Sony Projector's power is not turning on, ensure that the lamp cover and filter holder are securely closed and tightened. After about 1 minute, attempt to turn the power on. Also, check the warning indicators.
Why does the power suddenly turn off on my Sony VPL-HW55ES?
If your Sony Projector's power suddenly turns off, check that “Power Saving” in the Setup menu is set to “Standby.” If it is, set “Power Saving” to “Off.”
Why is my Sony Projector showing 'Frequency is out of range!'?
The 'Frequency is out of range!' message on your Sony Projector indicates that the input signal is outside the projector's acceptable frequency range. Input a signal that falls within the projector's supported frequency range.
How to stop Sony Projector and connected equipment from operating at the same time?
To prevent your Sony Projector and connected equipment from turning On/Off, playing back, and operating at the same time, set “Control for HDMI”, “Device Auto Power Off”, and “PJ Auto Power ON” to “Off.”
How to fix image retention on Sony Projector?
If an image is left on the screen of your Sony Projector (image retention), turn off the power for a while to eliminate the retained image.
What to do if my Sony VPL-HW55ES Projector shows 'Please clean the filter.'?
If your Sony Projector displays 'Please clean the filter.', it is time to clean the air filter.
Why is my Sony VPL-HW55ES Projector remote control not working?
If your Sony Projector's remote control isn't working, start by replacing the batteries with new ones, ensuring they are inserted with the correct polarities. Also, be aware that fluorescent lamps near the remote control detector can cause interference. Finally, if you're using an optional 3D Sync Transmitter, make sure it's not interfering with the remote control detector.
What does it mean when ON/STANDBY flashes red on Sony VPL-HW55ES Projector (4 flashes)?
If the ON/STANDBY indicator on your Sony Projector flashes red with a repetition rate of 4 flashes, it indicates a broken fan. Consult with qualified Sony personnel.
What to do if my Sony VPL-HW55ES Projector has no picture?
If your Sony Projector displays no picture, ensure that all connections are properly made. Use the INPUT button to select the correct input source. If you are using a computer, set the computer signal to output from or only to an external monitor.
General| Display Technology | SXRD |
|---|---|
| Resolution | 1920 x 1080 |
| Brightness | 1700 ANSI lumens |
| Contrast Ratio | 120, 000:1 |
| Lamp Life | 6000 hours |
| Zoom Ratio | 1.6x |
| Lens Shift | Vertical: ±71%, Horizontal: ±25% |
| 3D | Yes |
| Projection Size | 40 to 300 inches |
| Dimensions | 407.4 x 179.2 x 463.9 mm |
| Inputs | 2 x HDMI, 1 x Component, 1 x Composite |
| Throw Ratio | 1.36 - 2.16:1 |
