To Next Page
R
Rose FloresSep 7, 2025
How to fix a dark picture on my Sony VPL-VW50 Projector?
- YyburnsSep 7, 2025
To fix a dark picture on your Sony Projector, adjust the contrast or brightness properly in the Picture menu.
How to fix a dark picture on my Sony VPL-VW50 Projector?
To fix a dark picture on your Sony Projector, adjust the contrast or brightness properly in the Picture menu.
How to fix a flickering picture on my Sony VPL-VW50 Projector?
To fix a flickering picture on your Sony Projector, activate “APA” and adjust the current input signal. You can also properly adjust “Phase” for “Adjust Signal” in the Screen menu.
How to fix a picture that is not clear on my Sony Projector?
To improve picture clarity on your Sony Projector, start by adjusting the focus. If that doesn't fully resolve the issue, leave the projector on for about two hours.
What to do if my Sony VPL-VW50 Projector says 'High temp.! Lamp off in 1 min.'?
If your Sony Projector displays 'High temp.! Lamp off in 1 min.', turn off the power immediately. Also, check to make sure that nothing is blocking the ventilation holes.
How do I fix 'Frequency is out of range!' on my Sony Projector?
If your Sony Projector displays 'Frequency is out of range!', input a signal that is within the acceptable frequency range of the projector.
Power| power consumption in operation | 300 W |
|---|---|
| power consumption in standby | 8 W |
| power requirements | AC 100 to 240 V, 1.3 to 3 A, 50/60 Hz |
Operating Environment| operating temperature | 5°C to 35°C |
|---|---|
| operating humidity | 35% to 85% (no condensation) |
Display| native resolution | 1080p |
|---|---|
| display resolution | 1920 x 1080 |
| contrast ratio | Up to 15000:1 |
Inputs and Outputs| component video input | 1 (Side) |
|---|---|
| composite video input | 1 (Side) Vp-p+/-2 dB sync negative (75 ohms terminated) |
| s-video input | Y/C mini DIN 4-pin type |
Weight and Dimensions| weight | 11 kg |
|---|---|
| measurements | 395 x 173.5 x 471.4 mm |
