Sony Walkman TCD-D7 - Writing Start IDs During Playback; Erasing Start IDs; Renumbering Program Numbers

22
Useful Function
When the optional adaptor kit RM-D3K or the wired remote controller RMT-D7 is used with
this unit, you will be able to do the following:
To write the start IDs during playback
You can write the start IDs in the desired
positions without erasing the contents of the
recording.
When the desired position on the tape is
located, the section of the tape lasting three
seconds from that position will be played back
repeatedly. (Rehearsal function)
-RPEHRSAL
SEAS
If the located position is not where you desired
the start ID to be written, you can move that
position in either direction by 0.3 second
increments by the following method:
Selected position
Each time you
press <4 on the
RM-D3K or RMT-D7
Each time you
press >> on the
RM-D3K or AMT-D7
¢The rehearsal function can only be repeated up to 16
times. After that, the unit shuts off automatically.
¢You can move the position of a start ID forward or
backward to the maximum of approx. 10 seconds.
Notes
eYou cannot move the start IDs which have already
been written manually. or it they have been written
automatically during recording. If you wish to move
start IDs, erase the existing IDs first. Then select the
desired sections before rewrite the IDs.
«You cannot write the start IDs while the rehearsal
function is in operation or if the * EEE” indicator
and “gf + TE” indication are flashing rapidly.
To erase the start IDs
You can erase the start IDs without erasing the
contents of the recording on the tape. (Only
when the unit is in the stop or playback mode.)
tore
< 1-ERRSE-
- e Y x
Pee OO
Note
If a start ID is erased, the PGM number which has
been written at the same position will be erased as
well.
To re-number the PGM numbers
(Re-number function)
You may need to renumber the PGM numbers
in the following cases:
— When the start IDs are written during
playback.
— When the recording has been resumed from
the middle of the tape so that the same PGM
numbers co-exist on one tape.
— When the start IDs have been erased
together with the PGM numbers so that
some PGM numbers are missing.
visa,
-PENUR-
27117 so
When the re-numbering is over, the tape will
rewind to the beginning automatically and stop
there.
Note
If a tape is used which has been recorded on another
DAT deck and has a start ID written at the beginning of
that tape, writing or re-numbering the PGM numbers
on that tape may not be done property.