Sony XEC-1000 - Specific Control Adjustments

[is] LOW BOOST control
Frequencies around 40 Hz can be boosted
at the maximum of 10 dB. You can choose
whether the low boost works towards SUB-
WOOFER output only or it works towards
botl: SUB-WOOFER and REAR outputs.
When you want to make it work only for
SUB-WOOFER output, set the switch
located on the left side of the contro! to the
SU8 ONLY position. Set the switch to SUB
& REAR when you make it work towards
bot) SUB-WOOFER and REAR outputs.
REAR MID CUT contro!
[f]] FRONT MID CUT contro!
Frequencies around 180 Hz can be cut at
the maximum of ~10 dB. You can also
select *Q factor value (1, 3, & with Q
switch.
*Q(Q factor of resonant circuits)
In general, Q represents the sharpness of a resonant
Circuit filter. The lower the Q, the more slowly the
signal level changes erlang qarahcierete pd
moved away from resonance. As contrasted with this,
the higher the Q, the more quickly the signal level
changes. In this unit, the Q represents a mid-cut
frequency bandwidth. When you set the Q switch toa
higher value position, the narrower the frequency
bandwidth will be selected.