To Next PageTo Next Page
Need help?Do you have a question about the Sony XK-8D and is the answer not in the manual?
Audio Specifications| frequency response | 30 ~- 16, 000 Hz |
|---|---|
| signal-to-noise ratio (A-weighted) TYPE IV cassette | 58 dB |
| signal-to-noise ratio (A-weighted) TYPE I cassette | 55 dB |
| Dolby NR effect | More than 8 dB (CCIR/ARM) |
| wow and flutter | 0.095% (WRMS) |
| fast winding time | Approx. 110 sec. (with Sony C-60 cassette) |
| stereo separation between channels | More than 30 dB |
Power| current drain | 300 mA (in playback mode) |
|---|---|
| fuse for the yellow lead | 3.15 ampere |
| accessories supplied fuse | 3.15 ampere .1, 1 ampere .2 |
Weight and Dimensions| dimensions | Approx. 178 x 25 x 185 mm |
|---|---|
| mounting dimensions | Approx. 178 x 25 x 142 mm |
| cassette drawer projection | Approx. 85 mm |
| weight | Approx. 1.2 kg |
1/2 DIN size, 25 mm height stereo cassette player.
Plays back the other side of a cassette continuously.
Locates the beginning of selections being played or the next selection.
Noise reduction system that reduces tape hiss noise.
Sets optimum equalization based on cassette type during playback.
Closes cassette drawer automatically if left open for over 15 seconds.
Releases tape surface from capstan/pinch roller when power is off to prevent damage.
Allow unit to cool if car parked in direct sunlight causing high temperatures.
Check connections and fuse if no power is supplied to the unit.
Use of cassettes longer than 90 minutes is not recommended except for long playback.
Contact your nearest Sony dealer for any questions or problems not covered.
Switch for Dolby NR processed tapes; indicator lights up when active.
Button to locate selection beginnings; indicator blinks during search.
Indicates the current tape direction.
Lights up for TYPE II (CrO2) or TYPE IV (metal) tapes.
Button to start tape playback.
Button to stop tape playback.
Button to open or close the cassette compartment.
Button to change tape playback direction mode.
Buttons for fast forwarding or rewinding the tape.
Phono jacks for audio output connection.
Press the open/close button to open the drawer, insert cassette, and press play.
Playback automatically continues to the other side upon completion.
Press the stop button to halt playback.
Press the stop button to halt playback and open the cassette compartment.
Insert cassette fully before closing; press open/close again if closed improperly.
Cassette drawer closes automatically after 10 seconds if left open.
Turn ignition key OFF and press stop button if the unit does not operate.
Press the open/close button to close the drawer; do not force it.
Press the open/close button again if the drawer does not open or close.
Table shows indicator direction for upper and lower cassette sides.
Use AMS to locate beginnings of selections on the upper or lower side.
Advance tape or resume playback after rewinding using specific buttons.
Selection may not be found due to noise, short spaces, or quiet passages.
Details tape track, frequency response, signal-to-noise ratio, and stereo separation.
Details line outputs, current drain, dimensions, weight, and accessories.
Guide on checking and replacing a blown fuse, and when to consult a dealer.
Use only specified amperage fuses to avoid serious damage.
