22
2000 MOBILE PRODUCT GUIDE – PART 2
Specifications
Circuit System
Inputs
Outputs
Speaker Impedance
Rated Outputs (at 14.4 VDC)
Hi-Current/Hi-Voltage:
Frequency Response
Harmonic Distortion
Input Level Adjustment Range
High-Pass Filter
Low-Pass Filter
Low Boost
Power Requirements
Power Supply Voltage
Current Drain
Dimensions (w/h/d)
Weight
Supplied Accessories
OTL (output transformerless) Circuit
Pulse Power Supply
RCA Pin Jacks
High Level Input Connector
Speaker Terminals – through out pin jacks
1-8 ohms (stereo)
2-8 ohms (when used as bridging amplifier)
50/100 W x 2 (20-20 kHz, 0.04% THD), at 4 Ω )
70/140 W x 2 (20-20 kHz, 0.1% THD), at 2 Ω )
140/280 W x 1 (20-20 kHz, 0.1% THD), at 4 Ω )
5-50 Hz (+0.5/-3 dB)
0.005% or less (at 1 kHz, 4 Ω)
0.2-4.0 V (RCA pin jack);
0.4-8.0 V (High level input)
50-200 Hz, -12 dB/oct
50-200 Hz, -12 dB/oct
0-10 dB (40Hz)
12 V DC car battery (negative ground)
10.5-16 V
At rated output: 26A (4 ohm hi voltage mode)
Remote input: 2 mA
Approx. 282 x 50 x 320 mm (11
1
/8 x 2 x 12
5
/8 in.) (not incl. projecting parts and controls)
3.3 kg (7 lb. 4 oz.) (not including accessories)
Mounting Screws (4); Terminal Cap (1)
XM-1002HX
2/1 Channel Amplifier
• MOSFET Switching Power Supply
• Switchable Hi Power/Hi Current Mode
• Variable 50-200 Hz Hi-Pass/Lo-Pass Filter
• 40 Hz EQ Boost, Hi Level In
• RCA Passthrough
• 100 W x 2 Ch at 0.04% THD
• 280 W x 1 Ch at 0.1% THD
• 140 W x 2 into 2 ohms at 0.1% THD
• Discrete Dual Differential Inputs
• Discrete MOSFET Outputs
Design and specifications subject to change without notice.
To Next Page
Need help?
General
