26
Adding tracks to a programme
1 Press (SHIFT), then press (4) (PLAY
MODE) for two seconds.
If you have labelled the disc, the bank edit
mode appears. Press (4) (PLAY MODE) to
display “P” above.
2 Press (2) (N) or (5) (n) to select the
track slot number where you want to
insert a track.
3 Push the SEEK/AMS control up or down
to select the track you want to insert.
4 Press (6) (ENTER) to enter the track.
The current track in that slot number and
the succeeding tracks shift down.
To continue inserting tracks, repeat steps 2
through 4.
5 When you finish inserting tracks, press
(4) (PLAY MODE) for two seconds.
6 Press (SHIFT).
Track slot number
RLAY MODE ENTER
DISC TRACK
RLAY MODE ENTER
DISC TRACK
Notes
• If you press a number button during programme
memory play, programme memory play is
interrupted, and playback of the selected disc
starts.
• “NO Data” appears in the display if no track is
stored in the programme.
• If a track stored in the programme memory is not
in the disc magazine, the track will be skipped.
• When the disc magazine contains no tracks
stored in the programme memory, or when the
programme information has not been loaded
yet, “Not ready” appears.
Erasing an entire programme
1 Press (SHIFT), then press (4) (PLAY
MODE) for two seconds.
If you have labelled the disc, the bank edit
mode appears. Press (4) (PLAY MODE) to
display “P” above.
2 Press (2) (N) repeatedly until “DEL”
appears.
3 Press (6) (ENTER) for two seconds.
The entire programme is erased.
4 When you finish erasing programmes,
press (4) (PLAY MODE) for two seconds.
5 Press (SHIFT).
RLAY MODE ENTER
DISC TRACK
RLAY MODE ENTER
RLAY MODE ENTER
To Next Page
Loading...
Need help?
General
