10
AT T POWER
MENUINPUT
MODE
LIST
SETUP
TOP M ENU ALBUM
+
ALBUM
–
MENU
DISPLAY
ENTER
VOL
SUBTITLE
AUDIO
OFF
INPUT
POWER
When NTSC Video is selected
VIDEO1
NTSC
When PAL Video is selected
VIDEO1
PAL
Selecting the input source
You can select the input source and colour system.
1 Press (POWER).
The power is turned on.
Tip
If your car has no ACC (accessory) position on the ignition key switch, and the POWER
SELECT switch is set to the B position, the monitor does not turn on by pressing
(POWER) on the card remote commander (page 6).
2 Press (INPUT) to select the desired input source.
Each time you press (INPUT), the indication changes in the following sequence:
3 Press V or v to select PAL or NTSC colour system.
Press either button while the source indication (such as “VIDEO 1”) is displayed.
POWER
INPUT
B VIDEO 1 B VIDEO 2 B VIDEO 3
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
