EasyManua.ls Logo

Sony ZS-RS80BT User Manual

Sony ZS-RS80BT
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
SERVICE MANUAL
Sony Corporation
Published by Sony EMCS (Malaysia) PG Tec
US Model
Canadian Model
AEP Model
UK Model
E Model
Australian Model
MHC-V02
HOME AUDIO SYSTEM
9-890-699-01
2019C80-1
©
2019.03
Ver. 1.0 2019.03
SPECIFICATIONS
Model Name Using Similar Mechanism ZS-RS80BT
Optical Pick-up Name EM101UBS WITH PWB, MOTOR
Note:
Be sure to keep your PC used for service and
checking of this unit always updated with the
latest version of your anti-virus software.
In case a virus aff ected unit was found during
service, contact your Service Headquarters.
Continued on next page
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(US models only)
Left/Right Channel:
With 5 ohm loads, both channels driven, from 700 Hz – 20,000 Hz;
rated 6 watts per channel minimum RMS power at stereo mode,
with no more than 0.7% total harmonic distortion from 250
milliwatts to rated output.
Speaker section
Speaker system:
2-way, Bass Reflex
Speaker unit:
Tweeter L/R: 40 mm (1 5/8 in), cone type
Woofer: 180 mm (7 1/8 in), cone type
Inputs
AUDIO IN L/R:
Voltage 2 V, impedance 47 kilohms
MIC/GUITAR:
Sensitivity 1 mV, impedance 10 kilohms
(When guitar mode is turned off .)
Sensitivity 200 mV, impedance 1 Megaohm
(When guitar mode is turned on.)
Disc player section
System:
Compact disc and digital audio system
Laser Diode Properties
Emission Duration: Continuous
Laser Output*: Less than 44.6 μW
* This output is the value measurement at a distance
of 200 mm from the objective lens surface on the
Optical Pick-up Block with 7 mm aperture.
Frequency response:
20 Hz – 20 kHz
USB section
Supported USB device:
Mass Storage Class
Maximum current:
1 A
(USB) port:
Type A
FM tuner section (Except AEP, UK)
FM stereo, FM superheterodyne tuner
Antenna:
FM lead antenna
Tuning range:
87.5 MHz – 108.0 MHz (50 kHz step) (Except US)
87.5 MHz – 108.0 MHz (100 kHz step) (US model)
BLUETOOTH section
Communication system:
BLUETOOTH Standard version 4.2
Output:
BLUETOOTH Standard Power Class 2
Maximum output power:
<9.5 dBm
Maximum number of devices to be registered:
8 devices
Maximum number of simultaneous connection
(Multipoint):
3 devices
Maximum communication range:
Line of sight approx. 10 m (32 ft)
1)
Frequency band:
2.4 GHz band (2.4000 GHz – 2.4835 GHz)
Modulation method:
FHSS (Freq Hopping Spread Spectrum)
Compatible BLUETOOTH profiles
2)
:
A2DP (Advanced Audio Distribution Profile)
AVRCP (Audio Video Remote Control Profile)
SPP (Serial Port Profile)
Supported codecs:
SBC (Subband Codec)
AAC (Advanced Audio Coding)
LDAC
1)
The actual range will vary depending on factors such
as obstacles between devices, magnetic fields around a
microwave oven, static electricity, reception sensitivity,
antenna’s performance, operating system, software appli-
cation, etc.
2)
BLUETOOTH standard profiles indicate the purpose of
BLUETOOTH communication between devices.
Supported audio formats
Supported bit rate and sampling frequencies:
MP3:
32/44.1/48 kHz, 32 kbps –
320 kbps (VBR)
AAC:
8/11.025/16/22.05/32/44.1/48 kHz,
5 kbps – 384 kbps (VBR)
WMA:
8/11.025/16/22.05/32/44.1/48 kHz,
48/64/96/128/160/192 kbps (CBR),
64 kbps – 161 kbps (VBR)
WAV:
8/11.025/12/16/22.05/24/32/44.1/
48 kHz (16 bit)
General
Power requirements:
AC 120 V, 60 Hz (US model)
AC 120 V – 240 V, 50/60 Hz (Except US)
Power consumption:
25 W
Power consumption (at the Power Saving mode):
0.5 W (When “BT STBY” is set to “OFF”.)
2 W* (When “BT STBY” is set to “ON”.)
Dimensions (W/H/D) (Approx.):
281 mm × 500 mm × 306 mm
(11 1/8 in x 19 3/4 in x 12 1/8 in)
Mass (Approx.):
6 kg (13 lb 4 oz)
Operating temperature:
5 °C to 35 °C (41 °F to 95 °F)
* The power consumption of the system will be less than
0.5 W when “BT STBY” is set to “OFF”.
Supplied accessories
Remote control (DC 3 V) (1)
R03 (DC 1.5 V) (size AAA) batteries (2)
FM lead antenna (aerial) (1) (supplied only for
certain areas)
AC power cord (mains lead) (1)
AC plug adaptor* (1) (supplied only for certain
areas)
* This plug adaptor is not for the use in Chile,
Paraguay and Uruguay. Use this plug adaptor in
the countries/regions where it is necessary.
Design and specifications are subject to change without
notice.
SYSSET
2019/02/2822:48:45(GMT+09:00)

Questions and Answers:

Sony ZS-RS80BT Specifications

General IconGeneral
BrandSony
ModelZS-RS80BT
CategoryStereo System
LanguageEnglish

Summary

Servicing Notes and Precautions

Optical Pick-up Handling

Advises on electrostatic discharge and flexible board care for optical pickup components.

Laser Diode Emission Check Safety

Provides safety instructions for checking laser diode emission to prevent eye hazards.

Disassembly Procedures

2-1. Disassembly Flow

Outlines the step-by-step procedure for disassembling the unit, including necessary jigs.

2-2. Left and Right Panel Removal

Details the steps and hardware for removing the left and right side panels of the unit.

2-3. Top Panel and Rear Panel Removal

Instructions for disassembling the top panel (VITO) section and the rear panel.

2-4. Motherboard Board Removal

Step-by-step guide to safely removing the motherboard from the unit.

2-5. SMPS Board and Bottom Chassis Removal

Procedures for removing the SMPS board and the bottom chassis section.

Test Modes and Resets

Panel Test Mode Procedure

How to use panel test mode to check display, LEDs, model, and buttons.

Cold Reset Procedure

Details the cold reset process to restore all user settings to factory defaults.

History Mode for Protector Events

How to access and check stored data when a PROTECTOR event occurred.

Troubleshooting Guides

SMPS Board Diagnosis

A flowchart for diagnosing issues with the SMPS board by checking output voltages.

Motherboard Amplifier Diagnosis

Diagnostic flowchart for 'PROTECTX' errors related to the motherboard and amplifier.

Related product manuals