Sony ZS-RS80BT - 2-6. Front Panel (VITO) Section Removal

MHC-V02
13
2-6. FRONT PANEL (VITO) SECTION
2 Insert the jig into a space and slowly
remove the front panel (VITO) section.
Note 1: When using a jig, please work
so as not to injure front panel
(VITO) section and speaker
cabinet.
2 Insert the jig into a space and slowly
remove the front panel (VITO) section.
Note 1: When using a jig, please work
so as not to injure front panel (VITO)
section and speaker cabinet.
Note 2: When installing the front panel (VITO) section,
remove the used glue and apply a new
glue to fix the front panel.
2 Insert the jig into a space and slowly
remove the front panel (VITO) section.
Note 1: When using a jig, please work
so as not to injure front panel
(VITO) section and speaker
cabinet.
3 All bosses are removed while moving
jig in the direction of the arrow, and
front panel (VITO) section is removed.
3 All bosses are removed while moving
jig in the direction of the arrow, and
front panel (VITO) section is removed.
7 front panel (VITO) section
4 Remove the
front panel (VITO) section
in the direction of an arrow.
:LUHVHWWLQJ
:LUHVHWWLQJ
total thirteen bosses
1 one screw
((1) (3.5 u 14), TAPPING)
5 terminal
(wide side) [blue]
6 terminal
(wide side) [red]
5 terminal (narrow side)
[blue/black]
6 terminal
(narrow side)
[red/black]
Push the protrusion, and
remove the terminal
(wide side) [blue].
Push the protrusion, and
remove the terminal
(wide side) [red].
Push the protrusion, and
remove the terminal
(narrow side) [blue/black].
Push the protrusion, and
remove the terminal
(narrow side) [red/black].
protrusion
loudspeaker
4cm (tweeter)
(L-CH) (SP1)
loudspeaker 4cm
(tweeter) (R-CH) (SP2)
protrusion
top side
top side
SYSSET
2019/02/2822:48:45(GMT+09:00)