Sophos RED 10 Quick Start Guide

Sophos RED 50 Quick Start Guide
1. Preparing the installation
Congratulations on your purchase of the Sophos RED 50 security appliance to
protect your data and computers of your branch office. This Quick Start Guide
describes in a few steps how to install the appliance.
Unpack the appliance and prepare the installation
After checking the completeness of the scope of supply, identify the unique
RED-ID that is printed underneath your unit.
For further reference, you might also want to write the RED-ID down in the
area below:
RED-ID: __________________________________________________________
Sophos RED 50 This Quick Start Guide Power supply Shielded RJ45
Appliance and Security Notes and cable Ethernet cable
Security Notes and
Regulatory Compliance
Sophos RED Appliances
Quick Start Guide
RED 50
Before you begin, make sure you
have a working Internet connection.
RED 50 Rev 1
WAN1 MAC Address:
WAN2 MAC Address:
3330mA
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
LISTED
E215284
I.T.E.
A0000014EE22E39

Sophos RED 10 Specifications

General

Brand	Sophos
Model	RED 10
Category	Network Hardware
Language	English