Sophos RED 10 Quick Start Guide

Sophos RED 50 Quick Start Guide
3. Powering up the appliance
Connect the RED 50 to the power supply
Connect the RED 50 appliance to the power supply from the scope of supply
and plug the power cord into the electrical outlet. The Power LED will turn
on and the system will boot. The LCD will show the message "Starting RED"
and the RED-ID.
4. Establishing a tunnel
Establish a tunnel to your central UTM appliance
The RED 50 will now automatically retrieve its configuration from the
Internet and establish a tunnel to your central office. After successfully
establishing the tunnel, the LCD will show the message "Tunnel is up
(wan1)" and either the IP address or the hostname of the UTM appliance to
which the RED 50 is connected.
Please also write down the second line as it will help your administrator to
troubleshoot in case of a failure:
IP address or hostname of UTM appliance:
________________________________________________________________
Starting RED
> A0000014EE22E39
If you don’t see this message or
if the red Error LED is on, please
refer to the Operating Instructions to
identify potential errors or contact your
administrator.
Tunnel is up (wan1)
> UTM 10.8.16.32

Sophos RED 10 Specifications

General

Brand	Sophos
Model	RED 10
Category	Network Hardware
Language	English