© Sortimo International GmbH MA 00057 | 2022-01-11 | 5 104
Attaching the block
Step 2 — Preparing the vehicle wall
▶ Prepare the attachment points on the vehicle
wall.
▶ Repeat these steps until all the attachment
points have been prepared.
▶ If a side wall cladding is to be installed in the
vehicle, the attachment points should be
transferred to the side wall cladding.
▶ Install the prepared side wall cladding in the
vehicle.
Step 3 — Attaching the block system to the
vehicle wall
▶ Attach the EcoFIX brackets to the block and
to the vehicle wall.
▶ Align the block system.
▶ Tighten the screw fixings to the following
torques.
To Next Page
Loading...